J
JackOrip
I think the flyback is going out.. it shows signs of burning. Not
much so i was hoping a little epoxy might fix it. Right now the set
is playing audio but no CRTs are lit. Two red indicators on the power
supply board are lit. Other than that I need a schematic or repair
manual to check the voltages and what they should be. I openly admit
Im not great with projection TV's. But this is a personal project so
please dont tell me to take it to a shop that specializes in
Projection TV's. I came here for help, so can someone look it up in
your handy dandy book and give me a pointer in the right direction. I
am more than willing to do the work i just need a little technical
info. Any one that might be willing?
Please email me if you'd like to send a diagram.. or reply here and
I'd be very thankful for the help.
much so i was hoping a little epoxy might fix it. Right now the set
is playing audio but no CRTs are lit. Two red indicators on the power
supply board are lit. Other than that I need a schematic or repair
manual to check the voltages and what they should be. I openly admit
Im not great with projection TV's. But this is a personal project so
please dont tell me to take it to a shop that specializes in
Projection TV's. I came here for help, so can someone look it up in
your handy dandy book and give me a pointer in the right direction. I
am more than willing to do the work i just need a little technical
info. Any one that might be willing?
Please email me if you'd like to send a diagram.. or reply here and
I'd be very thankful for the help.