J
John Knowles
We have a Laserjet II which we would like to maintain.
When turned on with no PC connected the lights come on the front panel and
the display says the printer is doing a self check. After a few seconds the
lights go out and the display reads "12 printer open". At no time can the
fans or motors be heard. I tried opening the top, depressing the microswitch
which is normally activated by the longish plastic tab on the cover, and
powering on. I do not see a fuser lamp glow when I do this.
I took the DC Power supply (RGI-1394 (02)) apart and checked the
microswitch. It's OK.
I do not have +24V between pins 1 and 14 on J212.
I do have 169V on the large electrolytic capacitor which must mean there is
rectified mains voltage ready for use by the switchmode circuit.
This is as far as I wanted to go without a circuit diagram.
Can anyone suggest where I might find a service manual with schematics or
just a DC power supply schematic?
John Knowles
Montreal
When turned on with no PC connected the lights come on the front panel and
the display says the printer is doing a self check. After a few seconds the
lights go out and the display reads "12 printer open". At no time can the
fans or motors be heard. I tried opening the top, depressing the microswitch
which is normally activated by the longish plastic tab on the cover, and
powering on. I do not see a fuser lamp glow when I do this.
I took the DC Power supply (RGI-1394 (02)) apart and checked the
microswitch. It's OK.
I do not have +24V between pins 1 and 14 on J212.
I do have 169V on the large electrolytic capacitor which must mean there is
rectified mains voltage ready for use by the switchmode circuit.
This is as far as I wanted to go without a circuit diagram.
Can anyone suggest where I might find a service manual with schematics or
just a DC power supply schematic?
John Knowles
Montreal