Maker Pro
Maker Pro

identifying disk type capacitor

I am trying to repair the air pump module for a select comfort bed. I believe it was damaged when i used a generator for backup power and had a loose wire in the plug and caused some surging.

I found a disk cap that is ruptured and left smoke stains on the board. It is a radial lead through hole type. However, i cannot make sense of the markings on the cap. They are as follows:

150V
594-BC
0115

There does not appear to be a manufacturer logo or marking. I am guessing the 150V is a voltage rating but cannot find anything that would be of the same type with that voltage rating.

Any help is appreciated.

David
 

Attachments

  • 2012-05-24_13-48-40_455.jpg
    2012-05-24_13-48-40_455.jpg
    46.6 KB · Views: 319
Last edited:
It looks promising, but I don't know the ratings, for the money I would say grab one and try it, the worst that will happen is it will be too small and you'll blow it again
 
Top