Maker Pro
Maker Pro

how can I cause static on a phone line?

S

seattle dave

I want to cause static or interference on a line that leads from
the wall to a callmaster IV made by Lucent. These are phones used in
call-centers... The line has eight wires and I think it is the same as

a computer data line?? There is no other power source to the Lucent
callmaster, so one of the wires must carry power. The wires are all
small however... It is the same cord as is attached to a computer modem

to a computer....


thanks for any help on this...


would a strong radio signal interfer??
 
C

CJT

seattle said:
I want to cause static or interference on a line that leads from
the wall to a callmaster IV made by Lucent. These are phones used in
call-centers... The line has eight wires and I think it is the same as

a computer data line?? There is no other power source to the Lucent
callmaster, so one of the wires must carry power. The wires are all
small however... It is the same cord as is attached to a computer modem

to a computer....


thanks for any help on this...


would a strong radio signal interfer??
You might want to review applicable law first.
 
D

Dr. Anton T. Squeegee

I want to cause static or interference on a line that leads from
the wall to a callmaster IV made by Lucent. These are phones used in
call-centers... The line has eight wires and I think it is the same as

(1) Locate a Tesla coil and a galvanized tub filled with warm salt
water.

(2) Step into tub, take firm hold of the output end of the Tesla
coil with one hand.

(3) Flip coil power switch to 'On' with your free hand.

This should provide a great deal of static. However, I don't think
much of it would leak into the phone lines.


--
Dr. Anton T. Squeegee, Director, Dutch Surrealist Plumbing Institute.
(Known to some as Bruce Lane, ARS KC7GR,
kyrrin (a/t) bluefeathertech[d=o=t]calm -- www.bluefeathertech.com
"If Salvador Dali had owned a computer, would it have been equipped
with surreal ports?"
 
Top