I replaced the Honeywell control board from an older Brinks security system and am trying to use the existing motion sensors without any luck. If I define the motion sensor as a Zone Type 1 (Entry/Exit), the motion sensor respond as expected and sound the alarm after the previously defined delay, but it I define the Zone Type as 4 or 10, which I'm assuming a motion sensor should be, the alarm doesn't sound after sensing movement and after the predefined delay. I can see that the motion sensor is picking up the movement as the LED lights when the zone is defined as 4 or 10. Can someone tell me what I'm missing? Thanks in advance for any assistance.
-
Categories
-
Platforms
-
Content