J
J.B.
Hello
I have a small coil whose wire is cut somewhere in the interior. I
believe that to fix it I should unwind the copper wire and wind again
the coil with new wire.
I have measured the wire diameter, and it seems to be about 0.07 mm. I
have purchased enough 0.071 mm wire (45 SWG) and am ready for
everything.
And here is where I would specially acknowledge any assistance: Do you
have any hints on how to wind so small a coil, with so thin a wire? Any
recommendation will be highly appreciated).
Thanks and best regards.
Jesus, in Spain
jbenajesATmotDOTupvDOTes
I have a small coil whose wire is cut somewhere in the interior. I
believe that to fix it I should unwind the copper wire and wind again
the coil with new wire.
I have measured the wire diameter, and it seems to be about 0.07 mm. I
have purchased enough 0.071 mm wire (45 SWG) and am ready for
everything.
And here is where I would specially acknowledge any assistance: Do you
have any hints on how to wind so small a coil, with so thin a wire? Any
recommendation will be highly appreciated).
Thanks and best regards.
Jesus, in Spain
jbenajesATmotDOTupvDOTes