With signals on both channels, how can I measure both channels without turning one channel off?
-
Categories
-
Platforms
-
Content
You can use a Mux.
hevans1944
Hop - AC8NS
Simple, you just apply a signal discriminator to the signals in both channels and measure whatever you please.
is this a procedural question on DSO?
I rarely do, but when in doubt RTFM read the fine manual.
...snip
Push the MEASURE button to perform auto measurements. There are 32 types of measurements and up to 8 can be displayed at a time. Turn the V0 knob to select an unspecified option. Press V0 or F6 when the red arrow icon stops on it. Then the following menu appears.
I rarely do, but when in doubt RTFM read the fine manual.
...snip
Push the MEASURE button to perform auto measurements. There are 32 types of measurements and up to 8 can be displayed at a time. Turn the V0 knob to select an unspecified option. Press V0 or F6 when the red arrow icon stops on it. Then the following menu appears.
Last edited:
hevans1944
Hop - AC8NS
When my new Hantek DSO 5202P gets too confusing, I just swap the test leads over to my ancient Tektronix 465B... losing the waveform storage ability of course. And the math functions. And the USB computer interface. And maybe some brightness of the trace if the sweep speed is very fast. Hmm. I knew there was a reason I shelled out big bux for a new 'scope. Maybe I should spend some time to RTFM too. 
There's a nice review of the Hantek DSO 5102B here.
There's a nice review of the Hantek DSO 5102B here.
Last edited:
Similar threads
