Hi,
This is my first post on here, and I'm hoping someone can offer some advice on a electronics problem, and maybe I can answer some posts where they may fall within my experience.
I have a Infocus LP240/250 projector with a broken FFC connector locking clip. I am hoping to find a new connector, in which I can remove the clip and replace the broken one. The problem is after looking around online and talking to DigiKey, I can't determine who the manuacturer of the connector is.
Here are the details and photo:
FFC 30 position SMT, right angle, 0.5mm pitch, top contact, ZIF push type lock.
The body is black, and the lock is brown. FCI uses the black/brown combination, but their current connector locks don't match.
The photo shown is showing a good connector with the lock intact:
Any help or hints would be greatly appreciated.
If anyone has a dead Infocus projector, I can help troubleshoot it.
Cheers,
B
This is my first post on here, and I'm hoping someone can offer some advice on a electronics problem, and maybe I can answer some posts where they may fall within my experience.
I have a Infocus LP240/250 projector with a broken FFC connector locking clip. I am hoping to find a new connector, in which I can remove the clip and replace the broken one. The problem is after looking around online and talking to DigiKey, I can't determine who the manuacturer of the connector is.
Here are the details and photo:
FFC 30 position SMT, right angle, 0.5mm pitch, top contact, ZIF push type lock.
The body is black, and the lock is brown. FCI uses the black/brown combination, but their current connector locks don't match.
The photo shown is showing a good connector with the lock intact:
Any help or hints would be greatly appreciated.
If anyone has a dead Infocus projector, I can help troubleshoot it.
Cheers,
B
