S
Steve
I'm installing a Autohelm auto pilot which has a remotely located. The
recommendation is a location that is low and near the center of motion.
However, the cable lead is only 25ft long. That's about 15ft short of what I
will need to reach the ideal area (mid ship).
Since the cable run is inside, I don't have any problem doing a splice and
seal of the cable. I'm just concerned if there might be some degradation of
the signal from the flux sensor..
I'm think, "not a problem" but I would appreciate comments on this..
Steve
s/v Good Intentions
recommendation is a location that is low and near the center of motion.
However, the cable lead is only 25ft long. That's about 15ft short of what I
will need to reach the ideal area (mid ship).
Since the cable run is inside, I don't have any problem doing a splice and
seal of the cable. I'm just concerned if there might be some degradation of
the signal from the flux sensor..
I'm think, "not a problem" but I would appreciate comments on this..
Steve
s/v Good Intentions
