Does anyone out there know much about the GE EV1 motor controllers? I
have the "logic board" or "ascillator" from one and wonder if it is
possible/feasible to use it with FETS for motor control - instead of
using SCR control with the associated commutation and tuning problems.
It has 10 connectors down each side (L1-10 and R 1-10) as well as a 14
pin connector on the back. It has 8 trim potsAt some point in my long
distant past I did have SOME documentation on it, but I can't find it
now.
have the "logic board" or "ascillator" from one and wonder if it is
possible/feasible to use it with FETS for motor control - instead of
using SCR control with the associated commutation and tuning problems.
It has 10 connectors down each side (L1-10 and R 1-10) as well as a 14
pin connector on the back. It has 8 trim potsAt some point in my long
distant past I did have SOME documentation on it, but I can't find it
now.
