C
CptDondo
I have a board with a bunch of TTL-level IO. It can handle a few
milliamps (about 10) per IO.
I would like to be able to control 120VAC loads with this board. The
relay bank I have needs 50 ma to drive each relay; too much for my
little board.
Does anyone know of a ready-made inexpensive relay that can switch 10A @
120 VAC and uses < 10ma to do so?
On a related note, does anyone know of a ready-made solution for
connecting a typical ribbon cable to a screw-down termblock? I have a
16x2 0.1" header and I would like to take that to a screwdown termblock.
Thanks,
--Yan
milliamps (about 10) per IO.
I would like to be able to control 120VAC loads with this board. The
relay bank I have needs 50 ma to drive each relay; too much for my
little board.
Does anyone know of a ready-made inexpensive relay that can switch 10A @
120 VAC and uses < 10ma to do so?
On a related note, does anyone know of a ready-made solution for
connecting a typical ribbon cable to a screw-down termblock? I have a
16x2 0.1" header and I would like to take that to a screwdown termblock.
Thanks,
--Yan