B
billcalley
Hello All,
I am using PADS Logic 2007, and no matter where I look I cannot
find a way to run a real ERC to see if there are any unconnected nets
or open pins in the finished schematic (is the text-based "Reports"
function under File all there is??). And since I cannot find a way to
perform an ERC, I also obviously cannot find a way to have all errors
marked visually on the schematic, nor to jump to these errors on-
screen. I clearly remember being able to do all of this in earlier
PADS versions. (As a related question, I also cannot see where I can
assign unused pins with an "X" for a "Not Connected" so as to be
ignored during an ERC). How can I perform a real connectivity check
in this new PADS??
Many Thanks!!
-Bill
I am using PADS Logic 2007, and no matter where I look I cannot
find a way to run a real ERC to see if there are any unconnected nets
or open pins in the finished schematic (is the text-based "Reports"
function under File all there is??). And since I cannot find a way to
perform an ERC, I also obviously cannot find a way to have all errors
marked visually on the schematic, nor to jump to these errors on-
screen. I clearly remember being able to do all of this in earlier
PADS versions. (As a related question, I also cannot see where I can
assign unused pins with an "X" for a "Not Connected" so as to be
ignored during an ERC). How can I perform a real connectivity check
in this new PADS??
Many Thanks!!
-Bill