J
jesup
What would be the impact of caps on the output lines to a speaker if it's
being driven in differential mode? Say 10uf in series on each line, with
a 16ohm speaker? I can calculate a normal single-ended RC circuit, but
I'm not sure about this case. Would the low-frequency phase shifts match
or go in opposite directions (which would cause cancellation by the two
drivers at low frequencies)?
Thanks!
##-----------------------------------------------#
Delivered via http://www.electrondepot.com
Electronics Enthusiasts' Community of the Ne
Web and RSS access to your favorite newsgroup -
sci.electronics.design - 448567 messages and counting
##-----------------------------------------------##
being driven in differential mode? Say 10uf in series on each line, with
a 16ohm speaker? I can calculate a normal single-ended RC circuit, but
I'm not sure about this case. Would the low-frequency phase shifts match
or go in opposite directions (which would cause cancellation by the two
drivers at low frequencies)?
Thanks!
##-----------------------------------------------#
Delivered via http://www.electrondepot.com
Electronics Enthusiasts' Community of the Ne
Web and RSS access to your favorite newsgroup -
sci.electronics.design - 448567 messages and counting
##-----------------------------------------------##