Maker Pro
Maker Pro

Can't end thread with "Warmest Regards" - i's treated as spam..

Status
Not open for further replies.
Hi, for some reason if I try to end a thread with "Regards", "Warmest Regards" or similar I get this error:
The following error occurred:
Your content can not be submitted. This is likely because your content is spam-like or contains inappropriate elements. Please change your content or try again later. If you still have problems, please contact an administrator.
I am not native speaker but I've received official emails with this word. Is it inappropriate?
Greetings, best wishes and have nice day ;P
 
Last edited by a moderator:
I don't think I did. Perhaps you don't have many messages and the software is looking for spam?
Anyway, thanks in advance is usually sufficient.

Regards. Martin
 

Harald Kapp

Moderator
Moderator
I'm not aware that there is a ban on a friendly cmplimentary close.
However, I will bring this issue forward to our admins.

Warmest Regards,

Harald
 
Status
Not open for further replies.
Top