I have a project with school, we must create a jumping robot and for the electronics we chose a arduino pro mini with some leds, buttons, potentiometers and a buzzer. We want to drive a 12v motor with a mosfet. Now we have created the circuit on a breadboard, but now we want it on a perforated board (18x24 matrix). I've tried a few times in fritzing a design but I lack the experience to create a nice looking board. Can anyone help me? or just give me a few tips to get going?
A few sidenotes: the mosfet is lose of the board with the motor and diode for easy replacement, the power is stepped down from 12v to 5v by a dc-to-dc converter so we dont risk to blow it up since the pro mini can only accept up to 12v and the battery is 12.8v fully charged.
Here is the scematic on breadboard: (we will use a arduino pro mini 5v)
Greetings and many thanks!
Sten Hurkmans
A few sidenotes: the mosfet is lose of the board with the motor and diode for easy replacement, the power is stepped down from 12v to 5v by a dc-to-dc converter so we dont risk to blow it up since the pro mini can only accept up to 12v and the battery is 12.8v fully charged.
Here is the scematic on breadboard: (we will use a arduino pro mini 5v)
Greetings and many thanks!
Sten Hurkmans