W
Wild Bill
Hi.. I've got a few of these units that I'd like to be able to use for other
signal switching purposes, without including a projector.
Each of these units have numerous RGB/sync and Video In cards installed, and
they power on, but no output is passing thru.
RCVDS 800 Remote Controlled Video/Data Selector
RCVDS 400 Quad
RCVDS 3 Quad
Can these units be used without projectors?
Do they require the handheld IR remote controls to operate them?
As they are, they don't pass video thru to the output connector.. do I need
to make a special connector for the projector connector to enable signals to
pass thru?
If so, does anyone have the specific pin connections info for any of the
above units?
Could someone comment as to the input capabilities, such as 800 x 600 SVGA
or other specs?
Any help/suggestions would be greatly appreciated.
Cheers
WB
signal switching purposes, without including a projector.
Each of these units have numerous RGB/sync and Video In cards installed, and
they power on, but no output is passing thru.
RCVDS 800 Remote Controlled Video/Data Selector
RCVDS 400 Quad
RCVDS 3 Quad
Can these units be used without projectors?
Do they require the handheld IR remote controls to operate them?
As they are, they don't pass video thru to the output connector.. do I need
to make a special connector for the projector connector to enable signals to
pass thru?
If so, does anyone have the specific pin connections info for any of the
above units?
Could someone comment as to the input capabilities, such as 800 x 600 SVGA
or other specs?
Any help/suggestions would be greatly appreciated.
Cheers
WB
