When I run the internal calibration routine on my WaveTek 288
signal generator, I get the error: ERR OFSTGAIN
The documentation simply says check motherboard, phase board,
and output board, which doesn't narrow it down a whole lot!
It would be nice to know what calibration is touching during the event
that causes the offset gain error, but that's not described in the manual.
Bessides the general advice to "replace all the capacitors", anyone
seen this and fixed it?
Scott
signal generator, I get the error: ERR OFSTGAIN
The documentation simply says check motherboard, phase board,
and output board, which doesn't narrow it down a whole lot!
It would be nice to know what calibration is touching during the event
that causes the offset gain error, but that's not described in the manual.
Bessides the general advice to "replace all the capacitors", anyone
seen this and fixed it?
Scott