Harman kardon Signature Series 2.1
All channels working. I let it run for a few couple of hours and everything seems to be ok, but when i put the volume up to hear it louder, it Keeps going into protection mode. Regardless if i use only one speaker, a large speaker, a small speaker, or a different pre-amp.
I was wondering if anyone recognizes this issue and knows what i should replace, test or look for on the board.
All channels working. I let it run for a few couple of hours and everything seems to be ok, but when i put the volume up to hear it louder, it Keeps going into protection mode. Regardless if i use only one speaker, a large speaker, a small speaker, or a different pre-amp.
I was wondering if anyone recognizes this issue and knows what i should replace, test or look for on the board.