Maker Pro
Maker Pro

after a bulk erase...

S

Stranger

Hi,

I have a question from the 16F628A datasheet:

after entering programming mode and issuing a Bulk Erase command, I can't
tell if the program counter is still at 0000h after the bulk erase
operation.
But is it so? I assume it must be the same for most 16F devices.

Stranger
 
P

petrus bitbyter

Stranger said:
Hi,

I have a question from the 16F628A datasheet:

after entering programming mode and issuing a Bulk Erase command, I can't
tell if the program counter is still at 0000h after the bulk erase
operation.
But is it so? I assume it must be the same for most 16F devices.

Stranger

Microchip has the programming specifications of its PICs available on their
site. Usually the most reliable information. You will not need this
informaton unless you're building a programmer. If that's the case you can't
do without.

petrus bitbyter
 
Top