Addin RP3-DGTL keypad to Napco 816

[Total nerd]

I want to add a second RP3-DGTL keypad to a Napco 816 panel. All I
have to do is tie it into the 4-line bus and set the jumpers in the
back of the keypad to the second pad? That's it?
Thanks!

 

[Total nerd]

I have access to the PC loader if that's what you mean. I know how to
add/remove devices, configure zones, etc... I've just never added a
keypad.

 

[Bob La Londe]

go into the keypad programming area and set each additional keypad to be in
the area where you want it... ie area 1.


I have access to the PC loader if that's what you mean. I know how to
add/remove devices, configure zones, etc... I've just never added a
keypad.

 

[Total nerd]

OK thanks. So, the only "hardware" modification I have to do is to
properly set the jumpers in Keypad #2. There is no weird keypad
combination I have to type-in or some strange jumper on the panel,
like the 3200 and 9600 have, right?
I can easily go into the PC Loader and add a second keypad to Area 1.
Thanks much