Hi
- I'm working with an Arduino and the Adafruit motor shield v2. I've got two steppers and a servo hooked up and a working 12 volt power supply, but after a few turns of the stepper motor, my voltage drops down in the 2.5V range and the shield stops working for a few minutes. None of the chips seem to be over heating either. Any ideas?
Here are the steppers and the servo:
stepper- https://www.sparkfun.com/products/10846
servo- http://www.adafruit.com/products/1143
Thanks,
Kyle
- I'm working with an Arduino and the Adafruit motor shield v2. I've got two steppers and a servo hooked up and a working 12 volt power supply, but after a few turns of the stepper motor, my voltage drops down in the 2.5V range and the shield stops working for a few minutes. None of the chips seem to be over heating either. Any ideas?
Here are the steppers and the servo:
stepper- https://www.sparkfun.com/products/10846
servo- http://www.adafruit.com/products/1143
Thanks,
Kyle
