Hello,
I'm making a 9v preamp piezo pickup for my acoustic guitar. I've found instructions here...
http://blog.makezine.com/2011/12/20/collins-lab-diy-contact-mic/
I've put them in DipTrace and I want to make a simple PCB to etch on to a copper blank.
I've attached two diptrace files for review. And I'll add a picture too.
I just need some advice or guidance if I'm on the right track. Any thoughts or comments is appreciated.
I've ordered the parts along with a perf board so can have a mock up before I do the final one.
Thank you.
I'm making a 9v preamp piezo pickup for my acoustic guitar. I've found instructions here...
http://blog.makezine.com/2011/12/20/collins-lab-diy-contact-mic/
I've put them in DipTrace and I want to make a simple PCB to etch on to a copper blank.
I've attached two diptrace files for review. And I'll add a picture too.
I just need some advice or guidance if I'm on the right track. Any thoughts or comments is appreciated.
I've ordered the parts along with a perf board so can have a mock up before I do the final one.
Thank you.