D
Dani
Model # KP-53XBR200, had bad convergence, replaced 2-STK 392-020, &
one 3.150 amp picofuse, now auto focus works ok, & overall convergence
is fine...just off a bit, but I get a code of E17G right after auto
focus is finished. I can't see how to get into the basic customer
convergence menu. It isn't in the customer menu. Is there a special
way to do convergence?
Thanks, Dani.
one 3.150 amp picofuse, now auto focus works ok, & overall convergence
is fine...just off a bit, but I get a code of E17G right after auto
focus is finished. I can't see how to get into the basic customer
convergence menu. It isn't in the customer menu. Is there a special
way to do convergence?
Thanks, Dani.
